afx light SPIN12-FX Manuel D'utilisation page 5

BACK LIGHT
AUTO TEST
FIRMWARE VERSION
FACTORY DEFAULTS
RESET
You will find the detailed DMX channel charts at the end of the manual.
Settings
DMX ADDRESS SETTING
Press the MENU, UP or DOWN button until "ADDR" is displayed, press ENTER.
The current address will now be displayed and flashing. Press the UP or DOWN buttons to find your
desired address. Press ENTER to confirm.
DMX CHANNEL MODE
Press the MENU button until "CHND" is displayed, press ENTER. Either "15CH", "27CH" or "60CH"
will be displayed
Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to confirm
and exit.
SHOW MODE (FACTORY PROGRAMS)
Press the MENU button until "SHND" is displayed, press ENTER. Select the desired show mode
among DMX, AUTO or SOUND.
Press ENTER to confirm.
SOUND SENSITIVITY
Press the MENU button until "SENS" is displayed, press ENTER.
A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the sound
sensitivity. 0 being the least sensitive and 100 being the most sensitive.
When you have found your desired setting, press ENTER to confirm.
PAN INVERSION
Press the MENU button to select PAN inversion, press ENTER. Either "YES" or "NO" will be displayed.
To activate the Pan inversion press the UP or DOWN buttons until YES is displayed, press ENTER
to confirm.
To deactivate Pan inversion, select NO and press Enter.
TILT1 INVERSION
Press the MENU button to select TIL1, press ENTER. Either "YES" or "NO" will be displayed.
To activate the Tilt1 inversion press the UP or DOWN buttons until YES is displayed, press ENTER
to confirm.
To deactivate Tilt1 inversion, select NO and press Enter.
TILT2 INVERSION
Press the MENU button until "TIL2" is displayed, press ENTER. Either "YES" or "NO" will be dis-
played. To activate the Tilt2 inversion press the UP or DOWN buttons until YES is displayed, press
ENTER to confirm. To deactivate Tilt2 inversion, select NO and press Enter.
TILT3 INVERSION
Press the MENU button until "TIL3" is displayed, press ENTER. Either "YES" or "NO" will be dis-
played. To activate the Tilt3 inversion press the UP or DOWN buttons until YES is displayed, press
ENTER to confirm. To deactivate Tilt3 inversion, select NO and press Enter.
ON, OFF
AUTO TEST
A V1.0 B1.0
YES, NO
YES, NO
www.afx-light.com
5 EN