Publicité
(Translation of the Original Instructions)
3. Release the control lever (16:A) to lock the
seat.
The seat is equipped with a safety switch that is
connected to the machine's safety system.
This means that when no-one is sitting in the seat
the machine cannot be started. (see 7.6.2).
6.15 BONNET
See 5.2 for how to access the fuel cock,
battery and engine.
6.16 QUICK-RELEASE SUPPORTS
These support allows the user to swap
from one attachment to another quickly
and easily.
The quick-release supports allow the user to move
the cutting means assembly quickly and easily
between two positions, i.e.:
• Normal position with the belt fully tensioned.
• Positioned 4 cm behind the normal position,
with the belt slackened, so that the cutting
means assembly moves closer to the base of
the machine.
Being as the belt tensioner is released from the
belt, the quick-release supports simplify belt and
cutting means assembly replacement, and also
make shifting to the washing position and service
positions easier.
Belt tension releasing (17; 18)
See also the instructions provided with
the attachment and with the quick-rele-
ase support.
1. Remove the cotter pins or lock pins (17:C)
from both sides.
2. Open the quick-release supports by pressing
on their rear sections with your heel (17:A)
Once
the
have been opened, the arms of the at-
tachment are free and no longer secu-
red to the hook-up device.
For any adjustment or maintenance
operation, replace the arms on the sup-
port and reclose.
1. Carry out the necessary corrective action,
e.g.:
• Release the belt.
• Replace the attachment by unhooking the arms
(19).
Tensioning the belt (17; 18)
First tension one side and then the other accor-
quick-release
supports
ENGLISH
ding to the instructions provided below.
Do not turn the lever using your hands.
Risk of crushing injuries.
1. Place your foot on the lever (18:A) and care-
fully turn it 180° forwards.
2. Install the cotter pin or lock pin (17:C).
3. Repeat the operation on the other side.
EN
15
Publicité
