Publicité
(Translation of the Original Instructions)
7.6.1 General safety check
Object
Fuel lines and
connections.
Electrical cables
Exhaust system.
Oil lines
Drive the ma-
chine forwards/
backwards and
release the driving
pedal.
Test driving
7.6.2 Electrical safety check
Status
The parking
brake pedal is not
pressed.
Engine running.
7.7
START-UP / OPERATION
When using the machine, the bonnet
must be closed and fastened shut.
Always use full throttle when using the
machine.
When starting the machine, wait for
2 seconds in starting position before
starting the engine.
1. Open the fuel cock (24).
2. Check that the spark plug cables are instal-
led on the spark plugs.
3. Check the PTO is disengaged (11:D; 12:D).
4. Do not keep your foot on the service/drive
brake (10:F)
Models [B&S Power Built] [B&S Intek]:
Cold start
1. Engage the transmission (14:A1)
2. Activate the parking brake (10:B)
3. Put the choke on (11:A).
4. Turn the key in the ignition and start the en-
gine.
5. When the engine is running, gradually acce-
lerate to maximum operating speed (11:A).
Result
No leaks.
All insulation intact.
No mechanical damage.
No leaks at connections. All
screws tightened.
No leaks. No damage.
The machine will stop.
No abnormal vibrations.
No abnormal sound.
Action
Result
Try to start the
The engine
machine.
will not start.
The driver
The engine
gets up from
is switched
the seat.
off.
ENGLISH
Before starting work with the machine,
wait a few minutes for the oil to warm
up.
Warm start.
1. Engage the transmission (14:A1)
2. Activate the parking brake (10:B)
3. Turn the throttle to full on (11:A)
4. Turn the key in the ignition and start the en-
gine.
To proceed see the instructions provi-
ded in heading 7.7.1.
Models [B&S Vanguard]:
Cold start
1. Engage the transmission (15:A1; 15:B1)
2. Activate the parking brake (10:B)
3. Turn the throttle to full on (12:A)
4. Pull the choke out completely (12:B1).
5. Turn the key in the ignition and start the en-
gine.
Before starting work with the machine,
wait a few minutes for the oil to warm
up.
Warm start.
1. Engage the transmission (15:A1-B1)
2. Activate the parking brake (10:B)
3. Turn the throttle to full on (12:A)
4. The choke must be pressed in (12:B2).
5. Turn the key in the ignition and start the en-
gine.
To proceed see the instructions provi-
ded in heading 7.7.1.
7.7.1 Operation
To operate with the machine proceed as described
below:
• Press the pedal (10:B) right down then release
it.
• Activate the pedal (10:F) to move the machine.
• Go to the work area.
• If front accessories have been installed, activate
the PTO (11:D, 12:D).
• Commence work.
7.8
STOPPING
To stop the machine, proceed as follows:
• Disengage the PTO (11:D; 12:D).
• Engage the parking brake (10:B)
• Allow the engine to idle 1-2 mins.
• Turn off the engine by turning the ignition key.
EN
17
Publicité
