Publicité
Les langues disponibles
Les langues disponibles
Heating up the oven
To remove the new cooker smell, heat up the oven when it is
empty and closed.
Turn the temperature selector to the maximum temperature.
1.
Switch off the oven after 45 minutes.
2.
Recleaning the oven
Clean the cooking compartment with hot soapy water.
1.
Fit the hook-in racks.
2.
Operating the hob
Notes
Appliances with a hob cover must only be switched on if the
■
hob cover is open.
The burner caps must always be positioned exactly on top of
■
the burner cups. The slots on the burner cup must be free
from obstruction. All parts must be dry.
Ensure that the burner is not subjected to draughts caused
■
by air conditioning systems, fans or similar appliances.
Switching on the gas burner
Press the control knob for the required burner and turn it to
1.
the
position.
—
The gas burner ignites.
Keep the control knob pressed for a few seconds until the
2.
flame stabilises.
Set the desired flame setting.
3.
How to operate your oven
Note that, in the case of appliances with a hob cover, the
burners in the oven must only be switched on if the hob cover
is open.
Oven lighting
Switching on the oven lighting
Turn the control knob to the
Switching off the oven lighting
Turn the control knob to the
The oven lighting switches off.
10
position.
^
position.
Û
Cleaning the burner caps and cups
Clean the burner caps (A) and cups (B) with water and
1.
washing-up liquid.
Dry the parts well.
2.
Place the burner cup (B) onto the burner (C).
3.
Position the burner cap (A) exactly on the burner cup (B).
4.
Cleaning the accessories
Before using the accessories, clean them thoroughly using a
cloth and warm soapy water.
Setting
Meaning
Economy flame, lowest power
˜
Large flame, highest power
—
The flame is not stable between positions
select a position between
If the flame goes out
Switch off the control knob. Wait one minute and switch the
burner on again.
:
Risk of fire!
If the flame goes out, gas will escape. Never leave the gas
burner unattended during operation. Ensure that there are no
draughts.
If the gas burner does not ignite
In the event of a power cut or damp ignition plugs, light the gas
burner with a gas lighter or a match.
Switching off the gas burner
Turn the control knob for the required hotplate to position
and
. Always
Û
—
and
.
—
˜
.
Û
Publicité
