Active 4.0-Z 2T Manuel D'instructions page 27

ENGINE (IN ORDER TO AVOID TROUBLES)
Regularly: it is important,in order to avoid engine overheating,
to remove dust and dirt from slots,from cylinder, cover and
fins using a brush or compressed air.
CHECK ENGINE OIL LEVEL
Check regularly the engine oil level.
- Put the engine on a level surface.
- Remove the oil gauge
- If the oil level is below the lower gauge level line refill with
the proper oil up to the upper level.
MAINTENANCE AT 20 hours working from new (only for
4 stroke)
Preferably when the oil is warm.
- Remove the oil gauge
- Place a cloth or paper towel to the area around the oil filter
hole
- Drain the oil by tilting the engine and draining the oil into a
pan or other receptacle
- Allow to empty then put the engine on a level surface.
- Fill with the oil (SAE 10W-30) to the point of overflowing the
Follow all the maintenance instructions previously described.
- Clean the brushcutter completely and lubrificate the metallic
parts.
- Empty fuel tank and run engine until dry.Store brushcutter
in a dry place.
10. MAINTENANCE SCHEDULE
filler neck
MAINTENANCE EVERY 50 hours working (only for 4
stroke)
Preferably when the oil is warm.
- Remove the oil gauge
- Place a cloth or paper towel to the area around the oil filter
hole
- Drain the oil by tilting the engine and draining the oil into a
pan or other receptacle .
- Allow to empty then put the engine on a level surface.
- Fill with the oil (SAE 10W-30) to the point of overflowing the
filler neck
- Clean the air filter.
- Check the spark plug and if necessary replace it.
MAINTENANCE AT 200 hours working
1) Clean the fuel tank and replace the fuel filter
2) Clean the engine.
3) Replace the spark plug.
4)* Remove the cylinder and clean off carbon deposits on
piston, cylinder and exhaust system.
5)* Disassembly the carburettor and replace the diaphragms.
6)* Check and adjust engine valve clearance.
*) As to the procedures for these items, please refer to
your ACTIVE dealer.
9. STORAGE
- Remove the spark plug,put a small amount of oil into the
cylinder rotate the crankshaft several times using the starting
in order to distribute the oil,put the spark plug back in.
ATTENTION: ATTENTION:
ATTENTION: ATTENTION: ATTENTION: all maintenance operations not reported in this
manual must be carried out by an authorized service center.
27
ENGLISH ENGLISH ENGLISH ENGLISH ENGLISH GB