Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Remove all single parts from the packaging and lay them on the floor
Check roughly that they are all there on the base of the assembly
steps. Please note that a number of parts are preassembled. This will
make it easier and quicker for you to assemble the equipment.
Assembly time: 45 min.
STEP 1:
Attach the stabilizer (1) at the supports (2L+2R).
1. Lay the both stabilizer (1) in shown direction down on floor and put
on the connection points the supports (2L+2R) so that the holes align.
Pay attention of direction by insert the supports (2) on the rear stabili-
zer (1). The welded nuts should be on inner side of support.
2. Put onto the screws M10x70 (10) one washer 10//20 (15) and
screw the supports (2) at stabilizer (1) tightly by using washer (15) and
nylon nuts M10 (17).
3. Push the dumbbell rack (3) from rear side through the holes of sup-
ports (2) and tighten them by using screw M8x60 (12), washer 8//16
(16) and nylon nuts M8 (18).
4. Put the long bar holder (4) in desired position into the supports (2)
so that the holes align and secure the position with handgrip screws
(20).
STEP 2:
Attach the connection tube (5) at supports (2L+2R).
1. Lead the connection tube (5) between the supports (2) as figu-
re shows and tighten it firmly by using screws M10x65 (11), washers
10//20 (15) and Nylon nuts (17).
STEP 3:
Attach the front foot (8) at cushion frame (6).
1. Put the front support tube (7) at front area connection point of
cushion frame (6) as shown in figure and secure the front support tube
(7) with screw M10x70 (10), washer10//20 (15) and nylon nut M10
(17). Attention. Use the middle hole of cushion frame (6) and the
upper hole of front support tube (7) for connection. Do not tighten
die connection point too much, so that the fold up construction has
smooth function. Note: Put in fold up and fold out position always the
safety pin (19) in align holes.
2. Put the front foot (8) into the front support tube (7), so that the
holes align. Put on each screw M8x15 (13) one washer 8//16 (16) and
tighten the front foot (8) at front support tube (7) firmly.
20
12 16
16
18
2
L
10
15
15
1
2
L
11 15
15 17
15
10
17
15
19
7
13 16
16
13
13 16
8
11
4
4
3
18 16
16 12
2
17
17
15
14
1
2
R
5
17
15
15
11
6
pull
fold
GB
25
20
3
R
10
25
25
25
Publicité
