Publicité
Les langues disponibles
Les langues disponibles
7. Installing your conditioner
The accessories (screws, plugs, washers) required to install the
evaporator are not supplied.
Your evaporator is supplied in UP version without assembly of the
grille and its raising part.
A. Up assembly
For UP assembly, you first need to break breakable part No.1 (Fig 1)
by hand and fasten the grille and its raising part using the screws
supplied (Fig 2).
Breakable part to be broken
2 screw sizes are supplied, small ones for fastening the grille. Large
ones for fastening the grille + raising part.
B. Down assembly
For Down assembly, do not break breakable part No.1 (Fig 1)
Follow the steps below to position the fan
1
1 Remove the tray by exerting a slight upward pressure and pull it
out towards you
12
N°1
Fig 1
Fig 2
1 2
3 4
2 Unscrew the 4 screws which hold in place the fan located behind
the coil
2
1
3 Uncouple the fan then turn it 180° to blow air downwards,
remembering to accompany it by its cable, by removing it from its
housing.
1
2
4 Reposition the 4 screws in the locations provided, then place the
cable in its new location.
4
180°
3
4
3
Publicité
