Publicité
Les langues disponibles
Les langues disponibles
3. Align the bolt holes in the tank collar bracket with the bolt holes located in the center plate of the manifold.
Using the previously removed screws, secure the center plate manifold to the collar bracket. NOTE: The
heater MUST be facing away from the tank once it has been attached to the collar bracket. Make sure that
tip switch bracket is between the tank collar bracket and the manifold center plate. (See Figure 5)
4. Make sure heater regulator is in the "OFF" position. Insert regulator's connector into tank's valve and turn
left (counter clockwise) with hand as much as possible. Do not overtighten. (See Figure 6)
Figure 5
5. Slowly open the LP cylinder valve.
6. Check all connections for leaks using a 50/50 mixture of dishsoap and water. Any bubbles appearing show
a leak. Remove and reconnect the Connector Nut to the valve.
BE SURE TO READ AND UNDERSTAND ALL OF THE SAFETY INFORMATION IN THIS MANUAL
BEFORE LIGHTING THIS HEATER.
HEATER HAS HIGH SURFACE TEMPERATURES. BE SURE TO KEEP CHILDREN, PETS AND
CLOTHING AWAY FROM THE HEATER. BE SURE TO KEEP BURNER AND HEATER
REGULATOR CLEAN AND FREE FROM ANY DEBRIS. MAINTAIN SAFE DISTANCES FROM
HEATER AS SHOWN.
Propane Tank Top Heaters Manual
ASSEMBLY
Figure 6
13
Publicité
