SilverCrest SSRM 10 A1 Mode D'emploi Et Consignes De Sécurité page 47

warning in advance by briefly pressing the "MODE" button (3).
The display indicates the volume level currently set. If no button is
pressed for approx. 3 seconds, the currently tuned frequency
appears on the display again. If the device is set to a value
between "5" and "15" when it is switched off, the scan radio
starts at volume "03" when it is switched on again.
The setting has no effect on the volume of the buzzer
for the alarm clock function. The buzzer volume is
always the same.
Automatic station scan with auto store function
To receive radio stations, it is necessary for the
supplied earphones (B) to be connected to the
earphone jack. The earphone cable serves as a
receiving aerial.
The most convenient way to search for stations and save them is
the automatic station scan with automatic saving of stations (auto
store function).
 Switch on the scan radio with the "On/Standby" button (6).
 Press the "MODE" button (3) for approx. 2 seconds to start the
automatic station scan. The automatic station scan always
starts at the lowest frequency (87.5MHz).
 The scan radio now searches the entire frequency range for
stations with strong signals. "SCAN" (14) flashes on the
display (1). The "FM" symbol (11) lights up and goes out
briefly once a station has been found and the station preset
SilverCrest SSRM 10 A1
English - 45