Cleaning The Milk Container - DeLonghi DINAMICA plus Mode D'emploi

26
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards ( g. 27);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP DETERGENT NO DISH WASHER
Clean the infuser without using washing up detergent as it
could be damaged.
6. Use the brush (D5) to remove any co ee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support ( g. 28), then push the PUSH symbol fully
in until it clicks into place;
Please note:
If the infuser is di cult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 29.
8. Once inserted, make sure the two coloured buttons have
snapped out ( g. 30);
28
27
9. Close the infuser door;
10. Put the water tank back.

14.10 Cleaning the milk container

To keep the frother e cient, clean the milk container every two
days as described below.
1. Remove the lid (E2);
2. Remove the milk spout (E5) and intake tube (E4) ( g. 31);
3. Turn the froth adjustment dial (E1) anticlockwise to the
"INSERT" position ( g. 31) and pull it o upwards;
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dishwash-
er safe, but must be placed in the top basket of the
dishwasher. Make sure there are no milk residues on the
hollow and groove under the dial ( g. 32). If necessary,
scrape the groove with a toothpick;
5. Rinse inside the froth adjustment dial seat with running
water ( g. 33);
29
17
30
31 32