Cleaning The Milk Frother - DeLonghi Magnifica EAM3200 Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EAM3200_manual_final
5/19/04
11:50 AM
Page 23
23
• Remove the water tank by moving the milk frother to the outside of
the machine.
• Wash the tank with warm water and mild detergent. Rinse and dry
thoroughly.
• Replace the water tank.
15.3 Cleaning the Drip Tray and Used Water Tray:
• The drip tray is fitted with a red level indicator, showing the level of
the water inside.
• When the indicator is visible, the drip tray and used water tray must
be emptied and cleaned.
• Wash the drip tray and used water tray with
warm water and mild detergent. Rinse and dry
thoroughly.
• Replace the used water tray and drip tray.
15.4 Cleaning the Coffee Spout:
• Check that the holes in the coffee spout are
not blocked.
• To clean them, carefully scrape the dry coffee
Figure 21
residues from the coffee spout with a needle
(Figure 21).

15.5 Cleaning the Milk Frother:

Note: The milk frother must be cleaned after
each use. Deactivate the steam function before
cleaning. Please proceed as follows (the
machine must be on during the cleaning of the
milk frother):
•Release a little steam for a few seconds by
turning the steam control dial counter-clockwise
Figure 22
until it stops. (Figure 7).
•With this operation, the steam nozzle discharges any milk that may
have been left inside. IMPORTANT: For health reasons, this operation
should always be performed to prevent previously
used milk from remaining inside the milk frother.
• With one hand, hold the milk frother handle and
with the other hand unscrew the milk frother by
turning it clockwise and then pull it down. (Figure
22)
• Carefully wash the milk frother and steam nozzle
in warm water.
• Check that the two holes (indicated by the
Figure 23
arrows in Figure 23) are not clogged. If necessary,

Publicité

Table des Matières
loading

Table des Matières