FMS 1400mm Pitts Manuel D'utilisation page 6

E
N
Model assembly
Installation of the horizontal and vertical stabilizers
1. Install the horizontal stabilizer into the fuselage
cutout and secure the assembly with screws.
2. Align the vertical stabilizer with the horizontal
stabilizer and push the surface down and forward
until it is held securely in place.
3. Secure the vertical stabilizer and tail wheel using
the included screws.
Pushrod installation
1. Install the pushrod to the control horn on the
vertical stabilizer as shown.
HKM3.0*10mm
KA2.6x12mm
6
HKM3.0*10mm