Danger Of Fire - Futurelight EVO-1 Mode D'emploi

When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Mount the device to your trussing system using an appropriate clamp.
For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with quick link with screw cap. Pull the safety-rope
through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must
not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the
fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
If the device shall be lowered from the ceiling or high
joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the
room.
Caution: Devices in hanging installations may cause
severe injuries when crashing down! If you have doubts
concerning the safety of a possible installation, do NOT
install the device!
Before rigging make sure that the installation area can
hold a minimum point load of 10 times the device's
weight.

DANGER OF FIRE!

DANGER TO LIFE!
27/63 51837515_V_1_0.DOC