Replacing The Fuse; Technical Specifications - Futurelight EVO-1 Mode D'emploi

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
DMX-control-channels:
Rotating gobo-wheel:
Outside diameter of the gobos:
Image diameter of the gobos:
DMX-512-connection:
Sound-control:
Dimensions (LxWxH):
Weight:
Maximum ambient temperature T
Maximum housing temperature T
Min.distance from flammable surfaces:
Min.distance to lighted object:
Fuse:
Accessory:
GE EHJ A1/223 24V/250W G-6.35 50h
OSRAM EHJ 64655HLX A1/223 24V/250W G-6.35
FUTURELIGHT Easy-1 remote control
FUTURELIGHT EX-6/32 controller
FUTURELIGHT EX-8/32 controller
FUTURELIGHT CP-240 controller
FUTURELIGHT CP-256/64 controller 16bit
FUTURELIGHT CP-512/64 controller 16bit
Wizard-512 USB DMX-Software + Interface
Wizard-1024 USB DMX-Software + Interface
FUTURELIGHT DES-3 DMX-terminator 3-pin
Please note: Every information is subject to change without prior notice. 10.08.2006 ©
230 V AC, 50 Hz ~
300 W
4
5 gobos
32 mm
27 mm
3-pin XLR
via built-in microphone
360 x 300 x 290 mm
10 kg
: 45° C
a
(steady state): 70° C
B
0.5 m
0.5 m
F 3 A, 250 V
No. 88289000
No. 88289010
No. 51834010
No. 51834046
No. 51834047
No. 51834265
No. 51834288
No. 51834295
No. 51860102
No. 51860110
No. 51834001
33/63 51837515_V_1_0.DOC