Power Supply Cord; Energy Saving Tips - Danby Premier DPAC 13009 Guide D'utilisation

IMPORTANT SAFETY INFORMATION
POWER SUPPLY
CORD
1) Connect the power supply cord to an
electrical outlet.
2) The power supply cord has two buttons
located on the head of the plug. One button is
marked "TEST", and the other is marked
"RESET". Press the "TEST" button; you will
hear a click as the "RESET" button pops out.
3) Press the "RESET" button; you will hear a
click as the button engages.
4) The power supply cord is now energized
and supplying electricity to the air conditioner
(on some products this is also indicated by a
light on the plug head).
ENERGY-SAVING
TIPS
1) Select a thermostat setting that suits your
comfort needs and leave at that chosen
setting.
2) The air filter is very efficient in removing
airborne particles. Keep the air filter clean at all
times.
3) Use drapes, curtains or shades to keep
direct sunlight from penetrating and heating
room, but do not allow drapes or curtains to
obstruct the air flow around the unit.
INTERNAL SAFETY
FEATURE
This unit is equipped with a fail-safe switch
mechanism that prevents the unit from
condensing water in the event the internal
reservoir becomes full or is accidentally
displaced. If this situation occurs, the (RED)
WATER FULL indicator light will illuminate.
This condition will remain steady until the
external water tank is emptied.
NOTE: No cooling will occur until the internal
tank is emptied and/or re-positioned. It may
take several minutes before the compressor
resumes normal operation.
The power cord supplied with this air conditioner contains a device
that senses damage to the power cord. To test if your power cord is
working properly, you must do the following:
NOTE: The power cord supplied with this air
conditioner contains a current leakage detection
device designed to reduce the risk of fire. In the
event the power supply cord is damaged, it cannot
be repaired and must be replaced with a new cord
from the product manufacturer.
• Under no circumstances should this device be
used to turn the unit on or off.
• The "RESET" button must always be pushed in
(engaged) for correct operation.
• The power supply cord must be replaced if it fails
to reset when the "TEST" button is pushed in.
Your Danby appliance is designed to be highly efficient in energy
savings. Follow these recommendations for greater efficiency.
4) Start your air conditioner before the
outdoor air becomes hot and uncomfortable, to
avoid an initial period of discomfort while the
unit is cooling off the room. Use of the
automatic start/stop programmable TIMER
feature can be a major asset in this regard if
utilized to the fullest extent.
5) When outdoor temperatures are cool
enough, turn the air conditioner off and use the
FAN MODE on HIGH, MED, or LOW. This
circulates indoor air, providing some cooling
comfort while utilizing less electricity.
dehumidifier mode, if the compressor cycle is
interrupted (water full condition, unplugged,
power failure, etc.) and reinstated immediately
thereafter (within 3-5 minutes), a compressor
protection circuit is automatically activated. The
compressor cannot operate during compressor
protection mode (this is normal). It may take 3-5
minutes before the protection circuit
self-deactivates.
4
CAUTION: During air conditioning and
DO NOT ATTEMPT TO START THE UNIT
(COMPRESSOR) DURING THIS PERIOD.