Fan - Danby Premier DPAC 13009 Guide D'utilisation

OPERATING INSTRUCTIONS (cont'd)
DEHUMIDIFIER
Note: During dehumidifier mode, the exhaust hose
does not have to be vented outdoors.
1) Press the ON/OFF key pad to switch the
unit on (Fig. H)
2) Press the MODE key (Fig. I) until the
DRY indicator illuminates on the control
panel (Fig. J). Each press of the MODE key
will advance to a different mode setting
(Cool-Dehumidifier-Fan-Auto).
3) When the dehumidifier mode is
activated, the transparent ring around the
button on the front of the device (Fig. K)
emits an ORANGE light.
IMPORTANT: There is no fan speed or
temperature adjustment during
dehumidifier mode. The fan speed is
factory set for Auto and the dehumidifier
operates continuously (non-stop)
regardless of ambient humidity level or set
temperature.
NOTE: During Fan Mode, the exhaust hose does

FAN

not have to be vented outdoors.
1) Press the ON/OFF key pad to switch the unit on (Fig. H).
2) Press the MODE key (Fig. I) until the FAN indicator illuminates on
the control panel (Fig. L). Each press of the MODE key will advance
to a different mode setting (Cool-Dehumidifier-Fan-Auto).
3) Press the FAN Key (Fig. M) to select the desired FAN SPEED
setting. Your selection will appear on the control panel. Each press
of the fan key will advance to a different fan speed (High- Med- Low)
as shown in Fig. N.
4) When the fan mode is activated, the transparent ring around the
button on the front of the device (Fig. O) emits a GREEN light.
IMPORTANT: the drain
hose must be installed
during dehumidifier mode
Fig. H
Fig. J
Fig. N
High
Med.
Low
9
Fig. I
Fig. K
Dehumidifier mode (orange)
Fig. L
Fig. M
Fig. O
Fan mode (green)