Important Safety Information; Electrical Specifications; Power Supply Cord - Danby DPAC8011S Guide D'utilisation Et Soins De Propriètaire

Important Safety Information

READ AND FOLLOW ALL SAFETY INSTRUCTIONS
FOR YOUR SAFETY: Read these instructions carefully before operating and keep them for consultation.
ELECTRICAL
SPECIFICATIONS

POWER SUPPLY CORD

• Check the available power supply and resolve any wiring problems
BEFORE installation and operation of this unit. All wiring must comply
with local and national electrical codes and be installed by a qualified
electrician. If you have any questions regarding the following instructions,
contact a qualified electrician.
• For your safety and protection, this unit is grounded through the power
cord when plugged into a matching wall outlet. If you are not sure
whether the wall outlets in your home are properly grounded, please
consult a qualified electrician.
Improper connection of the grounding plug can result in risk of
Fire, Electric Shock and/or injury to Persons associated with the
appliance. Check with a qualified service representative if in doubt
that the appliance is proplery grounded.
• DO NOT USE PLUG ADAPTERS OR EXTENSION CORDS WITH THIS
UNIT. If it is necessary to use an extension cord with this unit, use an
approved "air conditioner" extension cord only. (available at most local
hardware stores).
• To avoid the possibility of personal injury, always disconnect the power
supply to the unit before installing and/or servicing.
Do not leave this unit unattended in a space where people or
animals cannot react to a failed unit. A failed unit can cause
extreme overheating or death in such an enclosed,
unattended space.
The power cord supplied with this air conditioner contains a device that
senses damage to the power cord. To test if your power cord is working
properly, you must do the following:
1) Connect the power supply cord
to an electrical outlet.
2) The power supply cord has two
buttons located on the head of
the plug. One button is marked
"TEST", and the other is marked
"RESET". Press the "TEST"
button; you will hear a click as
the "RESET" button pops out.
3) Press the "RESET" button; you
will hear a click as the button
engages.
4) The power supply cord is now
energized and supplying
electricity to the air conditioner
(on some products this is also
indicated by a light on the plug
head).
3
WARNING
CAUTION
NOTE: The power cord supplied
with this air conditioner contains a
current leakage detection device
designed to reduce the risk of fire.
In the event the power supply cord
is damaged, it cannot be repaired
and must be replaced with a new
cord from the product manufacturer.
• Under no circumstances should
this device be used to turn the unit
on or off.
• The "RESET" button must always
be pushed in (engaged) for correct
operation.
• The power supply cord must be
replaced if it fails to reset when the
"TEST" button is pushed in.