Control Surface Centering - Horizon Hobby E-flite Turbo Timber 1.5m Manuel D'utilisation

EN
Model Assembly Continued
Horizontal Tail Installation
1. Slide the horizontal stabilizer joiner (A) into the hole in the rear of the fuselage.
2. Install the two piece (left and right) horizontal stabilizer as shown. Ensure the
control horn faces down.
3. Secure the horizontal stabilizer pieces in place using the two included 3 x 12 mm
self tapping screws (B).
4. Attach the pushrod keeper to the elevator control horn.
Pushrod keeper Installation
1. Insert the end of the pushrod with the 90˚ bend into the control horn and
insert the pushrod into the hole in the pushrod keeper.
2. Rotate the pushrod keeper and press into place on the pushrod until it
clicks into position.

Control Surface Centering

After assembly, transmitter setup and binding, confi rm that the control surfaces
are centered. If the control surfaces are not centered, mechanically center the
control surfaces before fl ying.
Set the trims and sub-trims to 0
1. If they are not centered, loosen the screw in the quick connector linkage on
the servo horn.
2. Slide the pushrod in the quick connector to change the length of the linkage
between the servo arm and the control horn so the control surface is centered.
3. Apply thread lock compound to the screw threads and tighten the screw to
secure the pushrod at the desired length.
6
3 x 12mm
self-tapping
button head
1.
Turbo Timber 1.5m
A
B
2.
90˚
90˚