Télécharger Imprimer la page

Retrospec Koa Instructions De Montage page 12

Publicité

Les langues disponibles

Les langues disponibles

5.2.1 Trip Clearing
The TRIP reset setting item can clear the single trip
information of the display. After entering the setting item,
the default option is n, press [UP] or [DOWN] button to
switch to y, and long press M button to save and exit to the
main interface.
5.2.2 Back Light Setting
The backlight setting use to set the backlight brightness. 1,
2 and 3 levels is indicating the backlight brightness levels.
1 is the darkest, 2 is the standard brightness, and 3 is the
brightest. The default value of the is 1. Press [UP] or [DOWN]
button to change the backlight brightness parameter,
and long press [MODE] button to save and exit to the
main interface.
5.2.3 Unit Setting
Enter the setting state, ST¹ means imperial system selection,
short press the [UP]/[DOWN] button to switch between
metric units (Km) and imperial units (Mph). Short press
[MODE] button to confirm the setting, and then enter the
ST² setting interface.
21
5.2.4 Wheel size settings
The TRIP reset setting item can clear the single trip
information of the display. After entering the setting item,
the default option is n, press [UP] or [DOWN] button to
switch to y, and long press M button to save and exit to the
main interface.
5.2.5 Exit Settings
In the setting state, long press [MODE]button (more than 2
seconds) to confirm to save the current setting and exit the
current setting state.
Trip Clearance
6. Operation Introduction
Interface
6.1 Power on/off
After hold the [MODE] button, the display starts to work and provides the working
power supply of the controller. In the power on state, hold the [MODE] button
to turn off the power supply of the e-bike. In the power off state, the display no
longer uses the power supply of the battery, and the leakage current of the display
is less than 1uA. If the e-bike is not used for more than 10 minutes, the display will
power off automatically.
6.2 User interface
Back Light Setting
Interface
Unit Setting
Interface
Wheel Size
Setting Interface
K5303 User interface
22

Publicité

loading