AYA ATV3F/2 Manuel D'utilisation page 54

You should use a good quality screwdriver to carefully,

fully tighten ALL of the terminal screws.
If when the hob is first switched on, only two of the zones

work, you s hould r echeck t hat the t erminal screws ar e al l
fully tightened. This should be done before contacting the
Customer Care Department.
IMPORTANT: The appliance must NOT be connected to the

mains supply by means of a 13A plug and socket.
This appliance must be wired into a 30 A double pole

switched f used sp ur o utlet, having 3 m m c ontact
separation an d p laced i n an easily ac cessible p osition
adjacent to the appliance. It should not be located
above the appliance and no more than 1.25m away from
it.
The cable can be looped if necessary, but make sure that

is not kinked or trapped when t he hob i s in position. Care
must b e t aken t o a void the c able b eing in contact w ith
hot parts of the appliance.
Replacing the mains supply cable
If the mains supply cable is

damaged, then it must be
replaced by an appropriate
replacement.
The mains supply cable should be

replaced in accordance with the
following instructions:
 Switch t he ap pliance o ff at
the control switch.
 Open the terminal block on the underside of the hob.
 Unscrew the terminal screws fixing the cable.
EN-15