AYA ATV3F/2 Manuel D'utilisation page 52

out cabinet,and make it centered.Ensure that the front edge
of the hob is parallel to the side edge of the work surface.
IMPORTANT: You m ust observe th e

ventilation r equirements sh own i n
the drawing opposite.
IMPORTANT: There are ventilation

holes around the outside of the hob.
YOU MUST ensure that these holes
are not blocked by the work top,
when you put the hob into position
(see drawing opposite).
IMPORTANT: Do not use a silicon

sealant to seal the appliance
against the aperture. This will make
it difficult to remove the hob from the aperture in future,
particularly if it needs to be serviced.
Carefully t urn t he h ob b ack o ver an d t hen gently l ower i t

into the aperture hole that you have cut out.
Fitting guidelines
The ceramic hob is manufactured to
work with two-phase alternating current
(400V2N~50Hz).The voltage rating of
the ceramic hob heating elements is
230V. Adapting the ceramic hob to
operate with one-phase current is
possible by appropriate bridging in the
connection box according to the
connection diagram below. The
EN-13
2
1