AYA ATV3F/2 Manuel D'utilisation page 51

Installing the hob
Remove the material and envelope of documents from the
packaging.
Before proceeding with installation read the work instructions
carefully.
Step.1
Put a towel or cloth on the
work surface.Place the hob
face down on the protected
surface.
Step.2
Apply the strip seal,supplied
with the hob,which is for
sealing it onto the work surface.
Do not use silicone. Apply the seal to the edge of the bottom
of the hob,leaving about 3mm from the edge of the glass.
Apply the seal all around the circumference.
Cut any excess and bring the two ends of the
seal together so they match.
Step.3
Fix the brackets(4 or 5 pcs) on the front side
and rear side by screw.Put the hob in the cut-
WARNING
Risk of cutting.
Be careful of cutting edges.
End parts in foamed plastic - be careful.
During transportation these could cause slight
injury or cuts.
EN-12