IEM Tel-O-Graph GSM Mode D'emploi page 81

Masquer les pouces Voir aussi pour Tel-O-Graph GSM:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Recommended safety distances between portable and mobile HF telecommunication devices and the
®
Tel-O-Graph
GSM, Tel-O-Graph
®
The Tel-O-Graph
GSM, Tel-O-Graph
which RF disturbance is under control. Keep the minimum distances between portable and mobile RF
telecommunication devices (transmitters) and the monitor specified below, depending on the output of the
communication device.
Nominal output of
transmitter P in W
0,01
0,1
1
10
100
The recommended protection ratio can be calculated in meters (m) for transmitters whose maximum nominal
output is not specified in the table above. To do so, use the equation for the column in question, where P is the
maximum nominal output of the transmitter.
NOTE 1: The higher frequency range applies for 80 MHz and 800 MHz.
NOTE 2: These guidelines may not apply in all cases. The diffusion of electromagnetic parameters is affected by
absorption and reflections from buildings, objects and people
®
GSM plus
®
GSM plus is intended for operation in an electromagnetic environment in
Protection ratio in relation to transmission frequency in m
80 Mhz to 800 Mhz
d = 1,2 * P(W)
0,12
0,38
1,2
3,8
12
Manufacturer's EMC guidelines
800 Mhz to 2,5 Ghz
d = 2,3 * P(W)
0,23
0,73
2,3
7,3
23
150 Khz to 80 Mhz
Not applicable
Not applicable
Not applicable
Not applicable
Not applicable
EN
81

Publicité

Table des Matières
loading

Produits Connexes pour IEM Tel-O-Graph GSM

Ce manuel est également adapté pour:

Tel-o-graph gsm plus

Table des Matières