Energetics Twister Stepper Notice D'utilisation page 13

GB
OPERATING INSTRUCTIONS
Auto ON/OFF
The computer will activate when you press
MODE or when you begin stepping. If there's
no signal for approximately 4 minutes, the
computer will automatically turn off. When you
are not stepping, meter shows STOP.
Display
Meter always displays Count at the top.
The bottom of the meter can display STRIDES/
MIN, TIME, or CAL. Press MODE to select which
function you want to display at the bottom. An
arrow points to the function displayed.
SCAN
If arrow points to SCAN, then the meter will
automatically rotate the display at the bottom of
the meter in the following sequence: STRIDES/
MIN, TIME, CAL. An arrow will point to the
function displayed.
Reset
Press and hold button 3 seconds to reset all
values.
NOTE
If there is a problem with the display, please
1.
replace the battery to improve results.
Replacing the battery will reset all values.
Please use one LR44 cell battery as a power
2.
supply.
HOW TO REMOVE BATTERY
Open the Meter (No. 5), remove the old battery
and install the battery the new battery into the
correct position.
STEP 1 :
STEP 2 :
STEP 3 :
13