Ryobi RBL26BP Manuel D'utilisation page 19

8. Wide sweeper nozzle
9. Nozzle
10. Primer bulb
11. Quick release fastening
12. Adjustable harness and chest straps
ASSEMBLY
UNPACKING
The product requires assembly.
■ Carefully remove the product and any accessories
from the box. Make sure that all items listed on the
packing list are included.
WARNING
Do not use the product if any parts on the packing list
are already assembled when you fi rst open the box.
The parts on the packing list are not assembled by the
manufacturer and require customer installation. Use of
a product that may have been improperly assembled
could result in serious personal injury.
■ Carefully inspect the product to make sure no
breakage or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
■ If any parts are damaged or missing, please call your
Ryobi service centre for assistance.
PACKING LIST
■ Backpack blower
■ Upper tube
■ Bellows tube
■ Lower tube
■ Nozzle
■ Wide sweeper nozzle
■ Adjustable harness and chest straps
■ Locking clamps
■ Bottle of 2-stroke lubricant
■ Operator's manual
■ Figure sheet
NOTE: Read and remove all hang tags and store with your
operator's manual.
English (Original instructions)
If any parts are missing do not operate the product until
the missing parts are replaced. Failure to do so could
result in possible serious personal injury.
Do not attempt to modify the product or create
accessories not recommended for use with the product.
Any alteration or modification is a misuse and could
result in a hazardous condition leading to possible
serious personal injury.
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark
plug wire from the spark plug when assembling parts.
ASSEMBLING AND DISASSEMBLING THE UPPER
TUBE AND BELLOWS TUBE
See Fig. 2.
1.
2.
3.
4.
ASSEMBLING AND DISASSEMBLING THE LOWER
TUBES AND NOZZLE
See Fig. 2.
1.
2.
3.
17
WARNING
WARNING
WARNING
Attach the bellows tube to the main housing outlet
and secure with a locking clamp.
Attach the trigger handle to the upper tube by inserting
the upper tube into the trigger handle hole. Secure the
trigger handle in place using the screw.
Attach the upper tube and the trigger handle assembly
to the bellows tube. Secure the assembly in place
using the locker clamp.
To disassemble, loosen the locking clamps using a
hex wrench. Pull the upper tube and bellows tube
from the main housing.
Insert the externally-threaded end of the upper tube
to the internall-threaded end of the lower tube. Rotate
the lower tube clockwise to tighten.
Attach the nozzle to the tube assembly and twist
clockwise to tighten.
To disassemble, rotate the lower tube and the nozzle
individually in a counterclockwise direction.