Publicité
Installation
RMUBRKT1 RMU Pan-and-Tilt Bracket Accessory
The RMUBRKT1 pan-and-tilt wall bracket (Figure 11) allows both pitch and yaw adjustment and is available from Bose. The bracket fits
the threaded inserts on the rear panel of loudspeakers.
CAUTION: Two lengths of M8 pan head screws are included. Use only the M8 x 20mm screws for attaching the bracket to RMU
speakers. The M8 x 45mm screws are for use with non-RMU loudspeakers.
Figure 11. Pan and tilt bracket and speaker insert spacing
RMUBRKT1 Pan-and-tilt bracket
Speaker plate
M8 x 20mm (4)
M8 x 45mm (4)
Flat washers (4)
To mount the RMU loudspeakers using the bracket:
1.
Remove the lower carraige bolt and separate the front and rear halves of the bracket.
RMU105 mounting holes
Speaker plate
2.
Attach the bracket to the wall. Follow the instructions provided with the wall bracket.
12 English
Wall plate
CAUTION: Choose a position and mounting method consistent with local building
codes and regulations. Ensure the mounting surface and the method of attaching
the loudspeaker to the surface is structurally capable of supporting the weight of
the loudspeaker. A 10:1 safety weight ratio is recommended.
RMU208 / RMU206 / RMU108 insert spacing
RMU105 insert spacing
Notes:
• To mount the RMU208, RMU206, or RMU108
horizontally, remove the speaker plate, rotate it
90 degrees, and reattach it.
• To mount the RMU105, remove the speaker
plate and use the two speaker plate mounting
holes for mounting the RMU105.
Lower carriage bolt
Installation and Safety Guidelines
Publicité
