Publicité
3.
Using the included T3 square drive, remove the plastic inserts on the rear panel of the loudspeaker and attach the bracket to
speaker using only the included M8 x 20mm screws.
4.
Hang the speaker on the wall-mounted half of the bracket and install the lower carriage bolt removed earlier.
5.
Adjust the pitch and yaw using the specified tightening torque.
8 ft-lb (11 Nm)
30°
7 ft-lb (9 Nm)
Installation and Safety Guidelines
M8 x 20mm
18 ft-lb (25 Nm)
Installation
English 13
Publicité
