STERWINS ECS2-35.3 Mode D'emploi page 223

2. SAFETY INSTRUCTIONS
or unplugging the power tool. Keep cord away from heat, oil,
3
0
sharp edges or moving parts. Damaged or entangled cords increase
the risk of electric shock.
5.When operating a power tool outdoors, use an extension cord
suitable for outdoor use. Use of a cord suitable for outdoor use reduces
the risk of electric shock.
6.If operating a power tool in a damp location is unavoidable,
use a residual current device (RCD) protected power supply. Use
of an RCD reduces the risk of electric shock.
Personal safety
1.Stay alert, watch what you are doing and use common sense
when operating a power tool. Do not use a power tool while
you are tired or under the influence of drugs, alcohol or
medication. A moment of distraction while operating power tools may
result in serious personal injury.
2.Use personal protective equipment. Always wear eye
protection. Protective equipment such as dust mask, non-skid safety
shoes, hard hat, or hearing protection used for appropriate conditions will
reduce personal injuries.
3.Prevent unintentional starting. Ensure the switch is in the Off
-position before connecting to power source and/or battery
pack, picking up or carrying the tool. Carrying power tools with
your finger on the switch or energising power tools that have the switch
on invites accidents .
4.Remove any adjusting key or wrench before turning the power
tool on. A wrench or a key left attached to a rotating part of the power
tool may result in personal injury.
5.Do not overreach. Keep proper footing and balance at all times.
This enables better control of the power tool in unexpected situations.
6.Dress properly. Do not wear loose clothing or jewellery. Keep
your hair, clothing and gloves away from moving parts. Loose
EN
222