Human Touch WholeBody Rove Mode D'emploi Et D'entretien page 5

ASSEMBLE THE CHAIR
Raise the Chair to the Upright Position
1. Plug the power cord into the rear of the chair and then into
a grounded wall outlet.
2. Turn the power switch located on the back of the chair base to
On. The chair automatically inclines to the upright position
(Fig.1).
3. Power off the chair, then unplug it.
Install the Foot and Calf Massager
1. Remove and retain the two clips from the foot and calf massager
mounting posts located on the front of the chair by prying the
tongue of each clip outward to release it (Fig.2).
Clip
Mounting post
Electrical connector
2. Place the massager into position in front of the
chair, then connect the air hose and electrical
connector (Fig.3).
humantouch.com
Fig.1
Fig.2
Air Hose
Fig.3
6
3. Position the massager mounting brackets to the right of the mounting posts, lift the massager from the
floor, then slide the mounting brackets onto the mounting posts (Fig.4).
Post
Mounting bracket
Fig.4
7