Human Touch WholeBody Rove Mode D'emploi Et D'entretien page 4

get ready
UNPACK THE BOX
Chair Base
Foot and Calf Massager
Clip (extra) Tablet Remote
CHOOSE A LOCATION
When deciding where to place your WholeBody Rove, consider the following:
• Place the unit on a flat surface, away from direct sunlight or any other direct heat source (to avoid fading).
• If you wish to place the unit on a hard surface, it is recommended that you place a piece of carpet or a soft mat
underneath it to avoid damaging the floor.
• To accommodate the footrest when deployed, make sure the area in front of the chair is clear for at least five inches.
• The chair moves forward as it reclines, so you can place it right next to the wall.
Recline
clearance
3"
humantouch.com
Power Cord
Tablet Remote 250 V, 3.15 A Fuses (2)
Holder
Clearance
5"
4
Setting up your Human Touch massage chair is easy.
Just attach the foot and calf massager, connect the
body pad, and install the tablet remote and holder.
Then plug it in, power it on, and you're all set!
MOVE THE CHAIR TO THE DESIRED LOCATION
1. Grasp the front of the chair side panels on both sides.
2. Lift up to rotate the chair onto its wheels.
3. Roll the chair on its wheels to the desired location.
4. Gently lower the chair all the way to the floor.
WARNING: Dropping the front of the chair to the floor may damage the chair and/or floor.
5