Insert Batteries - TFA Quadro 35.1098 Mode D'emploi

TFA_No. 35.1098 Anleitung_08_13
QUADRO – Wireless weather station
Important information on product safety!
• Do not place the unit near extreme temperatures, vibrations or shocks.
• Protect it from moisture.
• The outdoor transmitter is protected against splash water, but is not watertight.
Choose a shady and dry position for the transmitter.
5. Elements
5.1 Receiver (Basic unit)
LCD (Fig. 1)
Q Weather symbol
W Indoor temperature and humidity
E Temperature trend indoor
R Comfort level indicator symbol
T Display of outdoor temperature and humidity
T Channel number
U Temperature trend outdoor
I Battery icon for outdoor sensor
O Reception symbol of outdoor data
P Time
{ Alarm symbol
} Snooze symbol
q Moon phase
w Battery symbol for weather station
e Indication of seconds
r Date and weekday
Buttons (Fig. 2)
A1: TIME button
A2: ALARM button
A3: UP button
A4: DOWN button
A5: CHANNEL button
A6: SNZ button
Housing (Fig. 2)
B1: Wall mount hole
B2: Battery compartment
B3: Stand (fold out)
5.2. Transmitter (Fig. 3)
Buttons
C1: °C/°F button
C2: TX button
C3: Channel slide
12
22.08.2013 10:21 Uhr Seite 7
QUADRO – Wireless weather station
LCD
D1: Outdoor temperature and humidity
D2: Indication channel
D3: Reception symbol
D4: Battery symbol
Housing
D5: Wall mount hole
D6: Battery compartment
6. Getting started

6.1 Insert batteries

• Place both instruments on a desk with a distance of approximately 1.5 meter.
Check that no other electronic devices are close.
• Open the battery compartment of the transmitter by pressing the notch with your
thumb and than lift the cover.
• Remove the battery insulation strip.
• Insert the batteries into the battery compartment of the basic unit, observing the
correct polarity.
• All LCD segments will light up for about a few seconds
• The unit is now ready to use and starts to scan the outdoor sensor data.
6.2 Reception of outdoor values
• The basic unit automatically starts scanning the 433 MHz signal to register the
transmitter after batteries are inserted. If the reception of outdoor values fails, "- -"
appears on the display. Check the batteries and try it again. Check if there is any
source of interference.
• Manual initialization can be helpful. Press CHANNEL button for 3 seconds. The
registered channel will be cancelled.
• Press TX button on the transmitter. The transmission of the outdoor data takes
place immediately.
7. How to operate
7.1 Manual setting of clock, time zone and calendar
• Hold TIME button in normal mode. The year digit is flashing. Press UP or DOWN
button to adjust year.
• Using TIME button you can switch to month, day, day-of-week language, hours,
minutes, and time zone setting (+/- 12 h), adjust with UP or DOWN button.
• Confirm with TIME button.
• Day-of-week language: German (GE), English (EN), Italian (IT), French (FR), Dutch
(NE), Spanish (SP) and Danish (DA).
• Holding UP or DOWN button, you will enter fast mode.
• The instrument will quit automatically the setting mode, if there is no button used
within 8 seconds.
7.2 12 and 24 hours system indication
• Press UP button in normal mode to choose 12 HR or 24 HR system.
• In 12 HR system PM appears on the display after 12 h.
13