Garland FUM 250G-V19 Manuel D'instructions page 31

This replacement can be found in the official
distributors of the machine. The use of other spare
parts can cause risks, damage to the user, passers by
to the machine.
Do not adjust the carburetor. If necessary, take your
machine in for service. Carburetor adjustment is
complicated, and only the technical maintenance
service must do this. Incorrectly setting the carburetor
may cause damage to the engine and will be sufficient
cause for cancellation of the warranty.
8.1. PERIODIC MAINTENANCE
Perform regular inspections of the machine in order
to ensure effective operation of the machine. For a
complete service check, we recommend taking the
machine to your service technician at least once a
session.
Operation
•
Check
Air filter
Clean
Clean /
Spark
adjust
plug
Change
Fuel filter Check
Cylinder
Clean
fins
Screws
•
Check
and bolls
8.1.1. CLEANING THE AIR FILTER
A dirty air filter will restrict air flow to the carburetor,
implying a loss of power, malfunction and increase
• • • •
• • • •
• •
• • •
• • •
of fuel consumption in the machine. Remember to
always check the cleanliness of the filter, especially in
areas with extreme dust.
1. Remove the protective cap from the filter.
2. Remove the filter.
3. You can clean the dust from the outside of the filter
shaking it against a hard surface.
4. Clean the filter with soapy water.
5. Rinse the filter with plentiful clean
wáter.
6. Allow the filter to dry.
7. Once dry, moisten it with two drops
of oil (If you wet the filter with too
much oil the machine won't start).
8. Install the filter on the machine.
9. Place the protective cap.
Note: The engine must never function without the air
filter installed.
8.1.2. FUEL FILTER
The fuel tank is equipped with a filter. It is located at
the end of the fuel suction pipe and can be removed
with the help of a wire hook.
Periodically check the fuel filter.
Do not allow dirt in the fuel tank to prevent that the
filter gets dirty.
A dirty filter will produce difficulties in starting the
engine and operation anomalies or stopping of the
machine.
Check the fuel. If you see dirt, replace it.
31/96
English