Power Fist 9096686 Mode D'emploi page 8

9096686
3. Discontinue tool use if it does not work properly or air is leaking. Tag or
mark the tool as 'defective' or 'out of service' until repaired.
4. Check the manufacturer' s maximum pressure rating for air tools and
accessories. Compressor outlet pressure must be regulated to never
exceed the maximum pressure rating of the tool (see Specifications).
Exceeding the maximum PSI rating can create a bursting hazard, causing
injury and property damage.
a. The tool does not regulate the pressure level. The power output is
in direct proportion to the air pressure available. An external air
pressure regulator is required to safely use this tool.
5. Never use oxygen, combustible gas or any other bottled gas as a power
source. Any power source other than an air compressor could cause an
explosion and serious personal injury.
6. Turn OFF the valve and discharge any remaining air pressure after each
use or before adjusting the tool.
7. Do not leave the air tool unattended with its compressed air supply on.
Turn off the compressed air supply and bleed the air tool of any remaining
compressed air before leaving the air tool unattended.
8. Serious injury may occur from loose debris being propelled at high speeds
from the compressed air stream. Always wear OSHA approved safety
glasses to protect the eyes during operation of the air compressor.
9. Always turn off the air compressor and drain tank pressure completely
before attempting maintenance or attaching air tools. Release pressure
slowly from the system.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace
the missing part before operating. Failure to do so could result in a
malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
CONTENTS
Make sure that all items in the contents are included.
• Long Ram Hydraulic Jack
www.princessauto.com / 1-800-665-8685
CLEVIS-BOTTOM LONG-RAM PNEUMATIC/HYDRAULIC JACK V1.0
Page 8