Publicité
Les langues disponibles
Les langues disponibles
9096686
4.
Insert a bolt through the clevis mount and attachment point. Secure with
a washer, lock washer and nut.
INSTALL AN AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use with your
tool.
1.
Wrap the external threads of the coupler plug with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2.
Screw the coupler plug into the tool's air inlet and tighten with a wrench
until snug.
3.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected
directly to the air tool. To overcome this, connect a leader hose to the
tool. A quick coupler may then be used to connect the leader hose to the
air line hose.
OPERATIONS
RAISING A LOAD
Once the load is lifted to the desired height, support the load with jack
stands to prevent injury should the long ram hydraulic jack fail. Do not
work under a load that is supported only by a jack.
1.
Close the release valve. Insert the slotted end of the handle over the valve
and twist to the right.
2.
Insert the handle into the bottle jack's receiver.
3.
Pump the handle until the load reaches the desired height.
4.
Position supports, like jack stands, if the load will remain above ground
for an extended period. Consult the support device's manual for proper
placement. Also consult the section Raising and Lowering a Vehicle.
www.princessauto.com / 1-800-665-8685
CLEVIS-BOTTOM LONG-RAM PNEUMATIC/HYDRAULIC JACK
V1.0
Page 10
Publicité
