Slendertone Abs7 Mode D'emploi page 7

EXCLUSIVE PATENTED TECHNOLOGY
7 uses electro muscle stimulation (EMS) technology. This technology has been
SLENDERTONE ABS
used in hospitals and by physical therapists for over 50 years. Here is a summary of how EMS
technology works. The special
muscles contract and not only those directly under the GelPads.
Step 1
Signals are sent
between the gel pads
SETTING UP YOUR SLENDERTONE ABS7
Step 1 - Charge the battery. Insert your charger into an electrical outlet and
then connect it to your controller (Fig. a). It'll take approximately 2-3 hours to
fully charge the battery. Your controller is fully charged when all three sections
of the battery icon are full. The battery icon will flash when the battery is low
and needs to be recharged.
: Please ensure you only use the
NOTE
charging your controller. Do not leave your controller connected to the
charger when the battery is fully charged.
Step 2 - Connect the controller to the belt. The controller and belt must be
connected for your
SLENDERTONE ABS
into the belt connector as shown in Fig. b.
Step 3 - Place the gel pads on the belt.
(i) Turn the belt over so that the 3 silver studs are facing upwards.
(ii) Remove the three adhesive gel pads from their pack. There is 1 large
square gel pad and 2 smaller oval gel pads. One side of each gel pad has
a grid pattern on it while the other side is plain black.
(iii) Remove the covers from the patterned side of the large gel pad (Fig. c)
and place the patterned side of this gel pad inside the white square over the
middle silver stud.
(iv) Now remove the covers from the patterned side of the two smaller gel
pads and place them either side of the large gel pad (Fig. d).
3-pad design ensures that all of the abdominal
SLENDERTONE
Step 2
The signals switch on the
nerves which control the
abdominal muscles.
SLENDERTONE ABS
7 to work. 'Click' the controller connector
The nerves, in turn, cause
your muscles to contract
and relax rhythmically.
7 charger when
Step 3
Fig. a
Fig. b
Fig. c
Fig. d
7