Slendertone Abs7 Mode D'emploi page 19

Description of your unit's symbols:
There are a number of technical markings on your controller. These can be explained as follows:
The controller and belt are manufactured for Bio-Medical Research Ltd, Parkmore Business Park West,
Galway, Ireland.
The controller requires 1 x 3.6 volt (NiMH) DC battery pack DC is indicated by the symbol:
The Output Frequency indicates the number of pulses per second transmitted by the controller. This is measured
in hertz, which is indicated by "Hz".
Output (RMSA) means the maximum output root mean square current for each channel.
Output (RMSV) means the maximum output root mean square voltage for each channel.
/
This symbol means "Attention, consult the accompanying documents".
This symbol means type BF applied parts (electrodes).
This symbol on your product is to indicate conformity to the requirements of the Medical Device Directive
(93/ 42/EEC). 0366 is the number of the notified body (VDE). The CE mark applied also indicates that this
equipment complies with the requirements of the ROHS Directive (2011/65/EU) for the Restriction of
0366
Hazardous Substances in Electrical and Electronic Equipment.
Conforms to UL STD 60601-1.
Certified to CAN/CSA.
STD C22.2 NO 601.1
SN stands for 'serial number'. Inside the box, on the back of the controller is the serial number specific to this product.
The letter preceding the number indicates the year of manufacture, where "T" denotes 2014, "U" denotes 2015 etc.
The belt's batch number is represented on the belt packaging, by the number corresponding with the LOT symbol.
Rated Outputs – Voltage/Currents: X:70
Parameter
Output RMSV
Output RMSA
Output Frequency
DC Component: Approx.
Positive Pulse Width:
Negative Pulse Width:
Interphase Interval:
At the end of the product lifecycle, do not throw this product or batteries into the normal household
garbage, but bring it to a collection point for the recycling of electronic equipment.
Some product materials can be re-used if you bring them to a recycling point. By re-using some
parts or raw materials from used products you make an important contribution to the protection of
the environment. Please contact your local authorities if you need more information about collection
points in your area.
Waste Electrical and Electronic Equipment can have potentially harmful effects on the environment.
Incorrect disposal can cause harmful toxins to build up in the air, water and soil and can be harmful
to human health.
500Ω 1KΩ
7.35V 13.1V
14.7mA 13.1mA
50-70Hz 50-70Hz
0 C 0 C
200-315µs
200-315µs
200-315µs 200-315µs
100µs 100µs
1K5Ω
15.5V
10.3mA
50-70Hz
0 C
200-315µs
200-315µs
100µs
19