Slendertone Abs7 Mode D'emploi page 14

QUICK GUIDE TO SOLVING PROBLEMS
Problem
Display doesn't come
on and there is no signal
from the controller
The display is on but
there is no signal
The battery symbol is
flashing
The symbol has
appeared on the
display* and/ or the
controller is beeping
Unpleasant feeling
beneath the gel pads
The contractions are
very weak even when
the toning intensity is
high
"Err" appears on the
display
* The symbol always appears in conjunction with the left/right intensity indicators. If the left indicator
appears, there is a problem with the left gel pad, the right indicator acknowledges a problem with the right
gel pad and if both indicators appear there is a problem with either the middle gel pad or all three gel pads.
14
Possible Cause
The battery is low
The battery is low
The battery is low
Controller not properly
connected to the belt
The gel pads are on the
wrong way around
The covers are still on the gel pads
The gel pads are worn
The gel pads are not covering the
studs
The belt is loose or open on the body
Build up on the metal studs under
the gel pads
Poor gel pad contact with the skin
The gel pads are worn
Gel pads are not covering the
metal studs
Too many consecutive sessions
The gel pads are worn
The battery is low
Poor gel pad positioning
Gel pads are not covering the studs
Error message
Solution
Recharge the battery
Recharge the battery
Recharge the battery
Ensure the controller and belt are properly
connected
Ensure the black surfaces of the gel pads
are facing you
Remove the covers from the gel pads
Visit the website or your local retailer for
new gel pads
Make sure the gel pads fully cover the
metal studs
Refasten the belt properly
Remove gel pads and clean studs with a
dry cloth
Press the gel pads firmly against the skin.
Smear a few drops of water on the surface
of the gel pads. Make sure the controller is
OFF first
Visit the website or your local retailer for
new gel pads
Reposition the gel pads so the metal studs
are covered
You should just do one session per day on
any single body area
Visit the website or your local retailer for
new gel pads
Recharge the battery
See page 8 for correct gel pad positioning
Reposition the gel pads so the metal studs
are covered
Switch the controller off and on. The
controller should work without any problem.
If the error message persists call the careline
for further details