Publicité
Les langues disponibles
Les langues disponibles
8990848
ASSEMBLY & INSTALLATION
INSTALL AN AIR COUPLER PLUG
Prepare a standard 1/4 in. NPT coupler plug (sold separately) for use with your
tool.
1.
Wrap the external threads of the coupler plug with sealant tape.
a.
Wrap tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads unwrapped
for easier alignment.
2.
Screw the coupler plug into the tool's air inlet and tighten with a wrench
until snug.
3.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected
directly to the air tool. To overcome this, connect a leader hose to the
tool. A quick coupler may then be used to connect the leader hose to the
air hose.
OPERATIONS
WARNING! Disconnect the tool from its air supply before changing
accessories, servicing or performing maintenance
1.
Determine if you need to clamp or secure the workpiece.
2.
Disconnect the tool' s air supply from the air inlet.
3.
Point the tool tip downward. Press the latch and pull the magazine back.
4.
Insert a strip of fasteners.
5.
Release the latch and slide the pusher against the fastener and lock into
place.
6.
Reconnect the tool to the air supply.
www.princessauto.com / 1-800-665-8685
CLIPPED-HEAD FRAMING AIR NAILER
V1.1
Page 8
Publicité
