Publicité
Les langues disponibles
Les langues disponibles
V1.1
Problem(s)
Tools will not run.
Air flows freely
from exhaust.
Tool will not shut
off.
Loss of power or
erratic
performance.
Page 13
CLIPPED-HEAD FRAMING AIR NAILER
Possible Cause(s)
1.
Damage or excessive
wearing of internal
parts.
2.
Insufficient internal
lubrication.
1.
Throttle valve o-ring
dislodged from inlet
valve seat.
2.
Trigger mechanism
jammed or dirty.
1.
Excessive drain on
the air hose. Incorrect
size or type of hose
connectors.
2.
Moisture or restriction
in the air hose/tank
3.
Air compressor has
insufficient flow.
Suggested Solution(s)
1.
Have a qualified technician service the
tool.
2.
Replace tool or parts.
3.
Lubricate tool per air tool lubrication
instructions.
1.
Replace throttle valve o-rings.
2.
Clean trigger mechanism and lubricate.
1.
Check the air hose and confirm the hose
fitting is correct for the inlet bushing.
2.
Depressurize system and drain tank and
air hose of water.
3.
Ensure tool is connected to a
compressor with a rate flow that
matches the tool.
www.princessauto.com / 1-800-665-8685
8990848
Publicité
