Publicité
Les langues disponibles
Les langues disponibles
V1.1
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
NAILER
Problem(s)
Possible Cause(s)
Fastener driven
1.
too deep.
2.
Cannot drive
1.
fastener.
2.
3.
4.
Tool skips
1.
fasteners.
2.
3.
4.
5.
Tool is
1.
jamming.
2.
3.
4.
Page 11
CLIPPED-HEAD FRAMING AIR NAILER
The bumper is worn.
The air pressure is too high.
Inadequate air supply.
Inadequate lubrication.
The o-rings or seals are worn
or damaged.
The exhaust port is blocked.
There is a worn bumper or
damaged spring.
Dirt is lodged in front plate.
Dirt or damage is preventing
fasteners from moving freely
in magazine
The cylinder cover seal is
leaking.
The O-ring on the piston is
worn, dry or needs lubrication.
The fasteners are damaged or
incorrect.
The driver guide is damaged or
worn.
The magazine or nose screw is
loose.
The magazine is dirty.
Suggested Solution(s)
1.
Replace the bumper.
2.
Adjust the air pressure.
1.
Verify that the air supply is
adequate. Adjust air flow.
2.
Place 2 to 6 drops of pneumatic tool
oil on the air inlet.
Lubricate firing mechanism.
3.
Check and replace the O-rings or
seals
4.
Service and unblock exhaust port.
1.
Replace the bumper spring or the
pusher spring.
2.
Clean the drive channel on the front
plate.
3.
Clean the magazine.
4.
Replace the cylinder cover seal
washer.
5.
Replace and/or lubricate the O-ring.
1.
Change and use the correct
fastener.
2.
Check and replace the driver.
3.
Tighten the magazine.
4.
Clean the magazine.
www.princessauto.com / 1-800-665-8685
8990848
Publicité
