Publicité
Les langues disponibles
Les langues disponibles
8990848
Problem(s)
Possible Cause(s)
The nailer will
1.
not start.
Tool is making
1.
unusual
sounds.
2.
3.
Overheating
1.
2.
AIR TOOL
Problem(s)
Tool runs slowly.
Air flows slightly
from exhaust.
And/Or
Air flows slightly
from nozzle.
www.princessauto.com / 1-800-665-8685
CLIPPED-HEAD FRAMING AIR NAILER
Motor components are
defective.
The nailer's parts may be
rubbing or binding.
Electrical components may be
shorting.
Worn tool components
Forcing machine to work too
fast.
Blocked motor housing vents.
Possible Cause(s)
1.
Air flow blocked by dirt.
2.
Air regulator in closed
position.
3.
Air flow or air pressure
is too low.
4.
Damage or excessive
wearing of internal
parts.
Suggested Solution(s)
1.
Have a qualified technician service
the tool.
1.
Check for obstructions or
misaligned tool components.
Lubricate, repair or replace the
components based on the particular
problem.
2.
Disconnect tool from the power
source immediately. Have the tool
examined by a qualified technician.
3.
Check and replace worn parts.
1.
Allow machine to work at its own
rate.
2.
Blow dust out of motor using
compressed air.
Suggested Solution(s)
1.
Check air inlet filter for blockage.
a.
Pour air tool lubricating oil into air
inlet as per lubrication instructions
for clearing shipping grease.
b.
Operate tool in short bursts to
clear debris.
c.
If tool still jammed, clean tool
and lubricate per lubrication
instructions.
2.
Open the air regulator to the desired air
flow.
3.
Adjust air flow or air pressure to match
tool requirements (see Specifications).
4.
Have a qualified technician service the
tool.
a.
Replace tool or parts.
V1.1
Page 12
Publicité
