Publicité
Les langues disponibles
Les langues disponibles
8990848
2.
Check and tighten all loose screws, bolts and nuts.
3.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
4.
Maintain the tool' s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other lubricants are
not suitable and will damage the tool or cause a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool. Penetrating
oil acts as a solvent that will dissolve the tool' s grease packing and may
damage the o-rings, causing the tool to seize or malfunction.
1.
All air tools have an internal coating of grease to prevent corrosion during
shipping and storage. Remove this grease by adding a generous amount
of air tool oil in the air inlet and then run the tool under no load until the
exhaust is clear.
2.
Manually add a drop or two of air tool oil into the tool' s coupler plug
before each use and after every hour of continuous use. The tool will not
work properly without lubrication and parts will wear prematurely.
3.
Avoid adding too much air tool oil as this can cause premature power loss
and eventual tool failure. A qualified technician will need to take the tool
apart and clean out the excess oil.
4.
Apply a generous amount of air tool oil to the tool before storing it
for an extended period of time (overnight, weekend, etc.). Run the tool
for approximately 30 seconds to ensure the oil is evenly distributed
throughout the tool. Store it in a clean and dry location.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
www.princessauto.com / 1-800-665-8685
CLIPPED-HEAD FRAMING AIR NAILER
V1.1
Page 10
Publicité
