Klarstein FULL HOUSE DOWN AIR Mode D'emploi page 50

EN
50
BEFORE INSTALLATION
Preparation of the work surface
Cut out the work surface according to the dimensions in the drawing. For installation
purposes, keep at least 5 cm of worktop around the hole. Make sure that the thickness
of the worktop is at least 30 mm. Select a heat-resistant and insulating worktop material.
Wood and similar fibre-rich or moisture-binding material should only be chosen
as a work surface if it has been impregnated to avoid the risk of electric shock and
deformation due to heat.
Note: The safety distance between the sides of the hob and the inside of the worktop
should be at least 3 mm.
Note: The dimensions given in the table are in "mm".
10039858
L W H
880 520 62
10045394, 10045397
L W H
770 520 61
A B
775 495
A B
570 490
X F
min. 50 min. 3
X F
min. 50 min. 3