Hitachi NT 1850DF Manuel D'instructions Et De Sécurité page 25

USING THE HOOK
● When using the hook, turn off the power
switch (green light "OFF"). Pay suffi cient
attention so that the main equipment does
not fall.
If the tool falls, there is a risk of accident.
Hook can be installed on the left or right side.
(1) Removing the hook.
Remove the screws fi xing the hook with Phillips
screw driver.
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
Hook
NOTE
Hook can be used as a hanger.
USING THE NOSE CAP
● When attaching or detaching the nose cap,
be sure to remove your fi nger from the trigger
and remove all remaining fasteners and the
battery from the nailer.
WARNING
Groove
Screw
Hook
Groove
Screw
WARNING
If you like to protect the surface of workpiece against
scratches or markings made by the push lever, attach the
accessory nose cap to the push lever.
Remove all remaining fasteners and battery from
nailer.
Put the nose cap to the toe of the push lever.
When not using the nose cap, secure in the storage
compartment located on the reverse side of the
magazine.
Nose Cap
NOTE
● The nose cap may reduce nailing depth due to its
thickness. Re-adjustment of nailing depth is required.
CLEARING A JAM
If nails are jammed in fi ring head, remove it, and adjust the
nailing in the following order.
CAUTION
● Remove the battery from the Nailer.
Remove the battery from the Nailer.
Remove all nails.
English
Push Lever
Nose Cap
Magazine
25