Hitachi NT 1850DF Manuel D'instructions Et De Sécurité page 20

English
Turn on the Power switch by push and hold on Power
switch more than 1 second.
Make sure the power indicator is lighting in green,
and nailing operation indicator is lighting in blue.
(SINGLE SEQUENTIAL ACTUATION MECHANISM)
NOTE
● Do not press the push lever and/or pull the trigger
during the process of turning the power switch ON.
Doing so will prevent the power switch from turning
ON.
Light in blue
[Auto power off ]
When the power is turned on but the Nailer is not
used for 30 minutes, the Nailer is automatically
turned off . To turn on again, press the power
switch.
Never leave the Nailer with the power on. This
could result in an accident.
Nailing operation indicator
● Lighting (Blue):
SINGLE SEQUENTIAL
MECHANISM
● Blinking (Blue):
CONTACT ACTUATION MECHANISM
Make sure the battery indicator is not lighting or
blinking.
If the battery indicator is lighting or blinking in red, the
battery doesn't have enough power and it needs to be
charged.
(4) Remove the fi nger from the trigger and press the
push lever against the workpiece.
□ THE NAILER MUST NOT OPERATE.
20
Light in green
WARNING
ACTUATION
Do not pull the trigger
Depress
push lever
(5) Separate the push lever from the workpiece.
Next, point the nailer downward, pull the trigger and
then wait in that position for 5 seconds or longer.
□ THE NAILER MUST NOT OPERATE.
Pull the trigger
[Time out function]
When set in contact actuation mode, pull and
hold the trigger for at least 2 seconds to enter
time out mode.
Or when set in single sequential mode, press
and hold the push lever for at least 4 seconds
to enter time out mode. The LED will blink to
indicate time out mode.
The brad nailer is disabled in time out mode.
To return to normal mode, release the trigger or
lift the tool from the wood surface.