Publicité
Les langues disponibles
Les langues disponibles
English
NOTE
● The nails shown in page 13 can be loaded onto
the side guide groove of the magazine without any
adjustment.
Always keep the points of nails in contact with
Groove.
Magazine
Side guide
groove
Nail
Groove
(3) Slide the nail strip into the blade guide.
Blade guide
(4) Confi rm that nail strip is placed with side guide
grooves and Groove properly, then push the
magazine cover forward to be latched.
NAILER OPERATION
Read section titled "SAFETY" (pages 3–10).
● Operators and others in
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
22
Gap
Nail strip
DANGER
WARNING
● NEVER point tool at yourself
or others in work area.
● Keep fi ngers AWAY from
trigger when not driving nails
to avoid accidental fi ring.
● Do not use the electrical cord if damaged.
Have it repaired immediately.
● Choice of triggering method is important.
Please read and understand "METHODS OF
OPERATION" found below.
● Before starting work, check the nailing
operation switching device.
This metabo HPT nailer includes a nailing
operation switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
nailer will not operate correctly.
● Never place your face, hands or feet near
fi ring head when using.
● Do not drive nails on top of other nails or
with Nailer at too steep of an angle; nails can
ricochet and hurt someone.
● Do not drive nails into thin boards or near
corners and edges of workpiece. Nails can be
driven through or away from workpiece and
hit someone.
● Never drive nails from both sides of a wall
at the same time. Nails can be driven into
and through the wall and hit a person on the
opposite side.
● Never use Nailer which is defective or
operating abnormally.
● Do not use Nailer as hammer.
● Remove all remaining fasteners and battery
from nailer when:
1) doing maintenance and inspection;
2) checking proper operation of push lever
and trigger;
3) attaching or removing the nose cap;
4) cleaning a jam;
5) it is not in use;
6) leaving work area;
7) moving it to another location; and
8) handing it to another person.
● Remove battery from Nailer when:
1) loading nails;
2) turning the adjuster.
Publicité
