Publicité
Les langues disponibles
Les langues disponibles
This metabo HPT nailer is equipped with a nailer
operation switching device.
Use SINGLE SEQUENTIAL ACTUATION MECHANISM or
CONTACT ACTUATION MECHANISM in accordance with
the work to be performed.
Explanation of the various nailing operations
○ SINGLE SEQUENTIAL ACTUATION MECHANISM:
First, press the push lever against the wood; next,
pull the trigger to drive the nail.
After nailing once, nailing will not be possible again
until the trigger is released and pressed again.
○ CONTACT ACTUATION MECHANISM:
1. Pull the trigger.
2. Press the push lever against the wood to drive the
nail.
3. If the trigger is held back, a nail will be driven each
time the push lever is pressed against the wood.
METHODS OF OPERATION
This Nailer is equipped with the push lever and does not
operate unless the push lever is depressed.
There are two methods of operation to drive nails with this
Nailer.
They are:
1. Intermittent operation (Trigger fi re):
2. Continuous operation (Push lever fi re):
(1) Intermittent operation (Trigger fi re)
Use the SINGLE SEQUENTIAL ACTUATION
MECHANISM setting.
● For intermittent operation, Set the nailing
operation switch to SINGLE SEQUENTIAL
ACTUATION MECHANISM (Nailing operation
indicator is light in blue.) (i.e. Set to SINGLE
ACTUATION MECHANISM.)
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Set to SINGLE SEQUENTIAL ACTUATION
MECHANISM.
2) Pull the trigger rapidly and fi rmly.
Set the nailing operation switch to SINGLE
SEQUENTIAL
(Nailing operation indicator is light in blue.)
Position the nail outlet on the workpiece with
fi nger off the trigger.
Depress the push lever fi rmly until it is completely
depressed.
Pull the trigger to drive a nail.
WARNING
ACTUATION
MECHANISM
Remove fi nger from the trigger and lift the tool off
the wood surface completely.
To continue nailing in a separate location, move the
nailer along the wood, repeating steps
required.
NOTE
Operations
and
4 seconds of each other. If more than 4 seconds
pass after
the Nailer will not work properly. If this
happens, retry from
Nailing
operation
switch
Push lever
● A nail will fi re each time the trigger is
depressed as long as the push lever remains
depressed.
(2) Continuous operation (Push lever fi re)
Using CONTACT ACTUATION MECHANISM
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Do not press the nailer against the wood
with excessive force.
2) Separate the nailer from the wood as it
recoils after nailing.
Set the nailing operation switch to CONTACT
ACTUATION
MECHANISM
indicator is blink in blue.)
Pull the trigger with the Nailer off the workpiece.
Depress the push lever against the workpiece to drive
a nail.
English
should be done within
.
Nailing
operation
indicator
(Light in
blue)
Trigger
WARNING
WARNING
(Nailing
operation
–
as
23
Publicité
