Publicité
Les langues disponibles
Les langues disponibles
English
(4) Remaining battery level
While power switch ON, the battery remaining level
can be checked by status of LED lamp as below.
Status of indicator
LED do not light
LED (Red) blinks
LED (Red) lights
(5) Other functions
In case of operation error, LED lamps show as below.
Status of indicator
LED (Red) blinks
LED light
LED light blinks in an
interval.
• In case of too hot
condition, blinks in
1 second interval.
• In case of too cold
condition, blinks in
0.5 second interval.
After 10 seconds,
automatically turns off LED
light and Power switch.
LED (Orange) blinks
18
The battery remaining
power is enough.
The battery remaining
power is nearly empty.
The battery remaining
power is empty.
Recharge the battery as
soon as possible.
Machine is in too cold
(below 23°F (-5°C) or too
hot condition.
Allow the nailer to cool
or warm-up thoroughly in
adequate condition.
Error is occurred.
Once remove the battery.
Then attach the battery
and power ON again.
LED (Orange) lights
(6) How to use the LED light
While the power switch on, the LED light will
automatically light up the tip portion of the tool.
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
TESTING THE NAILER
● Operators
work area MUST wear safety
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
Contact metabo HPT for
inspection.
Light in green
DANGER
and
others
in
Publicité
