Hitachi NT 1850DF Manuel D'instructions Et De Sécurité page 24

English
Move the Nailer along the workpiece with a bouncing
motion.
Each depression of the push lever will drive a nail.
As soon as the desired number of nails have been driven,
remove fi nger from the trigger.
NOTE
Operations and
2 seconds of each other. If more than 2 seconds
pass after , the Nailer will not work properly. If this
happens, retry from
Nailing
operation
switch
Push lever
● Keep your fi nger off the trigger except during
nailing operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. This metabo HPT nailer may
bounce from the recoil of driving a nail and
unwanted subsequent nail may be driven,
possibly causing injury.
NOTE
● If all warnings and instructions are followed,
safe operation is possible with all two systems:
SINGLE SEQUENTIAL ACTUATION MECHANISM,
CONTACT ACTUATION MECHANISM.
● Always handle nails and package carefully. If nails
are dropped, collating bond may be broken, which
will cause mis-feeding and jamming.
● After nailing:
1) remove battery from the Nailer;
2) remove all nails from the Nailer;
24
should be done within
.
Nailing
operation
indicator
(Blink in
blue)
Trigger
WARNING
ADJUSTING THE NAILING DEPTH
To assure that each nail penetrates to the same depth,
be sure that the Nailer is always held fi rmly against the
workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
Remove the battery from the Nailer.
If nails are driven too deep, turn the adjuster to the
shallow side.
Adjustments are in half-turn increments.
Too Deep
Too Shallow
If nails are driven too shallow, turn the adjuster to the
deep side.
Stop turning the adjuster when a suitable position is
reached for a nailing test.
Connect the battery to the Nailer.
ALWAYS WEAR SAFETY GLASSES.
Perform a nailing test.
Remove the battery from the Nailer.
Choose a suitable position for adjuster.
Battery
Turn Adjuster
Flush
Turn Adjuster
Flush