Amprobe AT-8020 Mode D'emploi page 37

5. MAINTENANCE
Changing the Receiver Batteries
The battery compartment on the back of the Receiver is designed to make it easy for the
user to change the batteries. A screw is added to secure the battery in case the unit is
dropped. Four (4) AA alkaline or rechargeable NiMH batteries may be used. NiMH batteries
need to be removed to be charged.
Note: Batteries do not come pre-installed in the Receiver.
1. Make sure that the Receiver is turned off.
2. Use flat screw driver to unscrew the captive screw.
3. Remove the battery cover (Figure 5.1b).
4. Install batteries.
5. Replace the battery cover and secure it with the provided screw.
Figure 5.1b: Changing Receiver batteries
33
Battery Cover
4 x AA
batteries
Screw